Morris Minor with Comanche Kenya trailer tent

Sowing Seeds of Hope | Youth Work & Faith in Cornwall

Cultivating Purpose, Community, and Faith on the Cornish Coast

Project Log: Giving a Comanche Kenya Trailer a Second Life

I’ve decided to take my old Comanche Kenya trailer tent and transform it into a heavy-duty, general-purpose utility trailer. The tent internals are out, the old hinges are rusted through, and it’s time for a “farm-ready” overhaul.

The goal is to keep it lightweight and dry, but make it versatile enough to haul animal feed, wood, and the occasional trip to the tip.

Morris Minor with Comanche Kenya trailer tent
Morris Minor with Comanche Kenya trailer tent

The Design: The “Best of Both Worlds” Utility Build

I’m aiming for a Front-Tipper configuration. This means the lid hinges at the front (tow-hitch end) for easy side and rear access, but I’m using a quick-release system so the lid can be removed entirely for tall loads.

The Step-by-Step Plan

Strip & Prep

Remove all the old rusted hardware. The entire fiberglass body will be sanded with 240-grit to “key” the surface, ready for a total color change.

Structural “Sandwich” Reinforcement

Fiberglass can be brittle under load. I’ll be using 2-inch wide aluminium strips (3mm-5mm thick) to sandwich the fiberglass walls. These will be bonded with Sikaflex 221 and bolted through with A4 stainless steel fixings. For the front I will be using a continuous strip across the full 125cm width for the hinges. For the sides a 200mm vertical plates to mount the gas struts.

I am going to front-mount the hinges with Lynch pins/Dzus fasteners for tool-free removal. For the lift assist, twin quick-release gas struts to save my back when loading feed bags.

The Tailgate Mod

I’m planning to cut the rear panel and frame it with aluminium U-channel, adding a bottom-mounted piano hinge so it drops down for easy “slide-in” loading.

The Finish

A full GRP primer followed by several coats of Green Enamel (applied via foam roller for a tough, smooth finish).

For the interior a heavy-duty rubber stable mat cut to size to protect the floor and stop cargo from sliding around the Cornish lanes.

I’d Love Your Feedback!

I’m about to head to the garage to start the metalwork. Before I start drilling holes, I’d love to hear from anyone who has done something similar:

Gas Strut Pressure: Have you found a “sweet spot” for Newton force on a fiberglass lid? I don’t want it to fly open, but I want it to stay up!

The Tailgate: Is a piano hinge the way to go, or should I look at individual heavy-duty strap hinges?

Paint: Any tips for getting the best finish on old GRP?

Drop a comment below and let me know what you think of the plan!


Comments

Leave a Reply

Your email address will not be published. Required fields are marked *