If you’ve noticed your gear lever dancing around or the exhaust knocking against the floor, it’s likely time to refresh your engine steady bar. This original-type kit from ESM is a direct replacement for the factory setup and keeps the engine from rocking excessively under load.
Tools You’ll Need
- Spanners/Sockets: 7/16″, 1/2″, and 9/16″ AF.
- Flat-head screwdriver: To help lever the bushes into place.
- Copper grease: To prevent future seizing.
- A second pair of hands: (Optional, but helpful for aligning the bulkhead bolts).
The Installation Process
- Preparation
Ensure the car is on level ground. You shouldn’t need to jack it up, as the steady bar is accessible from the engine bay, but make sure the engine is cool to the touch. - Assemble the Bar
Before fitting it to the car, assemble the rubber bushes and washers onto the bar.
- The sequence usually goes: Nut > Cup Washer > Rubber Bush > (Chassis/Engine Bracket) > Rubber Bush > Cup Washer > Nut.
- Do not tighten these fully yet; you need plenty of “play” to get the bar lined up.
Mounting to the Bulkhead
Fit the bracket end to the bulkhead. If you are replacing an existing setup, use the original holes. If this is a new addition, ensure you are using the reinforced mounting point to avoid stress cracks in the sheet metal.
Connecting to the Engine
The other end of the bar attaches to the rocker cover or the engine block bracket. Slide the bar through the mounting hole. If it doesn’t align perfectly, you can gently rock the engine by hand to bridge the gap.
Setting the Tension
This is the most important part. You want the bar to be neutral.
- Tighten the nuts until the rubber bushes just begin to compress (bulge slightly).
- Do not over-tighten. If the bushes are crushed flat, they won’t absorb vibration, and you’ll feel every engine pulse through the steering wheel and floorboards.
The Double-Check
Start the engine and give it a few revs. Check that the bar is steadying the movement without transferring excessive noise into the cabin.
Top Tip
While you’re there, check the condition of your gearbox mounts. A steady bar does a great job, but it can’t compensate for perished mounts lower down.
Happy motoring!




Leave a Reply